Jump to content






Photo - - - - -

K2 Related

Posted by MSSK , 28 July 2012 · 1,827 views

K2 Related Frame-Relay

Configure R1 and R3 for frame relay,configuring R5 as the frame relay switch according to the following requirements:
• Use cisco LMI on FR switch on R5 and autosense on R1 and R3.
• Don't use any static frame-relay maps
• Use frame-relay encapsulation as "cisco"
• Use the DLCI assignment from the table below
• Use the point-to-point interface type,use the DLCI numbers as sub-interface number.
• Keep the layer 3 addressing and routing requirements in mind when configuring frame relay (use only the ip addresses specified in Diagram 1)

On R1
interface s0/1/0
encapsulation frame-relay cisco
no frame-relay inverse-arp
!
interface s0/1/0.231 point-to-point
frame-relay interface-dlci 231

On R3
interface s0/0/0
encapsulation frame-relay cisco
no frame-relay inverse-arp
!
interface s0/0/0.233 point-to-point
frame-relay interface-dlci 233

On R5
frame-relay switching
!
interface s0/0/0
no ip address
encapsulation frame-relay cisco
no frame-relay inverse-arp
clock rate 128000
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 231 interface s0/1/0 233

interface s0/1/0
no ip address
encapsulation frame-relay cisco
no frame-relay inverse-arp
clock rate 128000
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 233 interface s0/0/0 231

http://www.4shared.com/video/i_ZKBzV-/K2_Frame-relay.html




November 2019

S M T W T F S
     12
3456789
10111213141516
1718 19 20212223
24252627282930

Recent Entries

Recent Comments

Tags

    Search My Blog

    Categories

    Organization

    Community

    Downloads

    Test Providers

    Site Info


    Go to top