Jump to content

Johnsonrama

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

-7 Poor

About Johnsonrama

  • Rank
    Junior Member
  1. TSHOOT V4 1. R14 cannot connect host 10.1.1.7 using TELNET port 23 with source interface loopback0. Fix the problem so that the connection can be established. 2. Host 171.2.2.2 in VPN Site-A2 cannot reach host 171.1.1 of VPN site-A1. Fix the problem so that the connection can be established. 3. All the PE routers cannot see loopback0 address of other 3PE router’s from two next-hop in BGP table “ show ip bgp table ” , Fix the problem so that the BGP neighbor relationship is restores as following. 4. R8 cannot reach IPv6 server CC1E:200:200:: 200 (loopback 200) on R4. Fix the problem so that reach ability is established using any method. But do not use static route. 5. R19 cannot establish an EIGRP neighbor relationship with R17 and R18 Fix the problem so that the DHCP is restored. (Do not remove access-list and the configuration completely). 6. R22 cannot establish an OSPF neighbor relationship with R23. Fix the problem so that the OSPF neighbor relationship is restored. 7. The ICMP traffic stream from host 10.1.1.12 to host 10.1.1.8 is marked with TOS 128 and the traffic should be arrived at destination host with critical. Fix problem so that the stream can be marked with the desired precedence critical. 8. Telnet traffic from R20 to host 100.100.10.10 (Host 28’s loopback 100 not!!! R23 Okay!!!) should be translated with the Ethernet ip address of R22 as NAT source address. HTTP traffic from host 28 to host 100.100.10.10 (R23’s loopback 100) should be translated with the loopback ip address of R22 as NAT source address. Fix the problem so that it can be meet. 9. R16 and R15 cannot establish an Enhanced interior Gateway Routing Protocol (EIGRP) neighbor relationship. Fix the problem so that the EIGRP neighbor relationship is stored without removing authentication, authorization and accounting (AAA). 10. On R27, interface Ethernet 0/0 was shut down by someone. Fix the problem so that EEM can be triggered with “no shutdown” action. 11. R21 cannot reach host 192.168.20.1 Fix the problem so that the connection can be established. Tonight, I will be back to share everything with everyone!! Cheers, Johnson Rama. CCIE LAB _ Dubai.pdf
×
×
  • Create New...