Jump to content

lephuhai2501

Members
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About lephuhai2501

  • Rank
    Junior Member
  1. lephuhai2501

    JN0-680

    Hi mahbub808, Could you please share dump JNO-681? Thanks so much
  2. Hi all, D is wrong because N2 is symbol indicating external route, and using metric type 2.
  3. Hi all I know that when recovering password for Cisco Catalyst 6500 running IOS, I have to perform the following of these commands: -rommon1> confreg 0x2142 -rommon2> reset +The router reboots. However, it ignores the saved configuration. +Type no after each setup question or press Ctrl-C to skip the initial setup procedure. +Type enable at the Router> prompt.You are in enable mode and see the Router# prompt. BUT when I do the reset command, it reboots and decompresses the image and load the running config file, It does not appear like this : Would you like to enter the initial configuration dialog? [yes/no] I don't know why it happen like that. Can everybody help me to explain this problem and show me the way to repair it. Thanks and best regards Le Phu Hai
  4. Thanks crackerioe6. But I also haven't seen how broadcasts and multicast is handled exactly . Can you explain it or give me an documentary of reference ?
  5. Hi all! Please help me. can we use a routing protocol in optical network? If yes , is there any problem causing an error which prevent a routing protocol from routing in optical network. Thanks.
×
×
  • Create New...