Jump to content

chintoo

Members
  • Content Count

    27
  • Joined

  • Last visited

  • Days Won

    1

chintoo last won the day on November 17 2017

chintoo had the most liked content!

Community Reputation

4 Neutral

About chintoo

  • Rank
    Member
  1. Hi Antoni, I didn't get a 100% score (960), so i guess some of my answers must have been incorrect. Based on that, I would say Answers to all the questions in your post except for the below are fine. Q7: A is right. In my opinion, B is not correct since a Shared tree is calculated. May be pick one from other 2 options. Q10: this one didn' came in my exam. Q11: B Q17: Didn't came in my exam. Q26: C (my reason being, an APIC can as such operate fine even if all the APICs are down, the only downside being you wont be able make config changes. But in the Answers "zero" is not listed. The only other number which is referenced in the Book is "3". So I will chose 3) Q61: Didn't came in my exam. But i guess the question is around the Looped free and Looped L2 topologies. My suggestion would be to not to delay sitting for the exam. You don't want to keep it for too long in case there is a new revision or version change come out for the exam. So revise the question and take the exam Thx
  2. All, Passed the exam. Confirming all questions were from: Latest version of Antoni.pdf Hesseny2000 Main dump D&D were ACI and Subnet No new questions were in the exam !! Thank you everyone on this forum who have been sharing/learning and working collectively to nail the CCDP ARCH Exam. All the very best !!
  3. C - that's the best practice and is recommended.
  4. C - Weight is at the top of the BGP Route selection criteria. Weight is also local to the router and be setting a higher weight on a route the local router will select it as the best route and inject in the routing table for use.
  5. Some more questions ... would like to hear everyone's comments !! Which two statements correctly identify considerations to take into account when deciding on Campus QoS Design elements? (Choose two.) A. Voice needs to be assigned to the hardware priority queue. B. Voice needs to be assigned to the software priority queue. C. Call signaling must have guaranteed bandwidth service. D. Strict-priority queuing should be limited to 50 percent of the capacity of the link. E. At least 33 percent of the link bandwidth should be reserved for default best-effort class. Correct Answer: A C My opinion: B (as LLQ occurs in Software not Hardware), & C. Which configuration represents resiliency at the hardware and software layers? A. multiple connections and FHRP B. HSRP and GLBP C. redundant supervisor and power supplies D. dual uplinks and switches Correct Answer: A My opinion: C could be also valid
  6. Thanks Daniel .... explanation makes sense.
  7. Friends, Would like to get everyone's opinion on the below questions as to me the Answers appear to be incorrect.... With which of the following could EIGRP and OSPF achieve sub second convergence ? (Choose Two) A. BFD B. Triangle topology C. Square topology D. Ring topology E. Tuning timers F. IP SLA Correct Answer: AB My opinion: Should be A, E QUESTION 18 An organization is using a link state routing that is not dependent on IP addressing .Which action enable information across area boundaries in this organization ? A. Assign level 1 router interface B. Assign level 1 routers to different areas C. Assign level 2 router interface to the backbone area D. Assign level 2 router to different areas E. Assign level 2 router interface to different area Correct Answer: D My opinion: Should be C A network engineer is designing a network that must incorporate active-active redundancy to eliminate disruption when a link failure occurs between the core and distribution layer. What two technologies will allow this? (Choose two.) A. Equal Cost Multi-Path (ECMP) B. Rapid Spanning Tree Protocol Plus (RSTP+) C. Hot Standby Routing Protocol (HSRP) D. Rapid Spanning Tree Protocol (RSTP) E. EtherChannel (MEC) Correct Answer: AE My opinion: Should be A, C
  8. My opinion is, with L3 VPN as Customer is no longer in control of the Routing as its only peers up with PE router with Service Provider being in control of the routing within the MPLS cloud .... hence, if the customer were to have a requirement for a Secure Routing within the MPLS cloud then Customer needs to specify so. In L2 VPN the Customer is in control of the routing within the MPLS cloud as its peers occurs between CE routers via MPLS cloud. Thx.
  9. Hello friends, The latest version of v04.3 Antoni PDF ... has "C" marked of the below question. Am leaning towards "B". Any comments? Question 24 Which technology is an example of the need for a designer to clearly define features and desired performance when designing advanced WAN services with a service provider? A. FHRP to remote branches B. Layer 3 MPLS VPNs secure routing C. Control protocols (for example Spanning Tree Protocol) for a Layer 3 MPLS service D. Intrusion prevention, QoS, and stateful firewall support network wide Answer: C
  10. Hello Friends, Can anyone please share the link to the file "Hesseny2000 - RecentlySeenOnExam" Thanks !!
  11. Hello Friends. Members interested towards preparing for the CNNP DC Exam - 300-160 please join for Group Study, sharing materials, reviewing questions and answers and successfully clear the Exam !! In view of no valid dumps of the Exams on offer, this would be a good way for all of us to have a combined crack at the Exam. Thanks !!
  12. Lets all team up and share all the dumps floating around and then collectively go through them and determine the Right answers ...I'm pretty sure will be enough to crack the exam !!!
  13. We all should share all the dumps floating around and then collectively go through them and determine the Right answers ... I'm pretty sure will be enough to crack the exam !!!
  14. Hi Mate ... are you able to share the Passleader version that you have ... i am studying for the Track and going through the Cisco pdfs, online papers etc ... might be able to assist in answering the incorrect Questions ... correctly Infact, in absence of any valid materials anywhere ... all of us intending the sit for the 300-160 DC Design exam .. .. should share all the dumps floating around and then collectively go through them and determine the Right answers ... I'm pretty sure will be enough to crack the exam !!!
×
×
  • Create New...